Talaria Battery 72v 4464Wh 62Ah

High Power, Mega Long Range

ATOM 25Kw

(74.5Ah Equivalent @ OEM 60V)

ASI, EBMX, VTB, Torp, KO & Nucular Controllers Compatible

up to 18Kw 700Phase

Tough Protective 316 Stainless Steel Case
Fully Protected BMS
Single Discharge Connector

TRIPLE the Range over OEM High Power, Huge Range

Power: Very High (25Kw)
Range: Ultimate High (4464Kwh 297% Over OEM)
Height: Tall (385mm Seat lift recommended)

Battery Activation Required On Delivery

On delivery, please send us a request to have your battery activated.
This will also be regarded as confirmation that your battery has been received.

Talaria Battery 72v 4464Wh 62Ah High Power, Mega Long Range ATOM 25KW

Talaria Battery 72v 4464Wh 62Ah High Power, ATOM 25Kwbattery and was primarily designed for high power and HUGE long range. With a powerful aftermarket controller (see our controllers page) the set up for this battery will be 15-18Kw, depending on your motor. Please observe the specifications for your controller and motor. Exceeding the recommended limited may invalidate your warranty.

Exoskeleton /Casing

We have upgraded the casing to marine grade 316 stainless steel, so absolutely no rust issues here! Super tough and powder coated inside and out.

Connectors

The main battery to controller connectors we use are the same type as used by Talaria to keep everything compatible. This allows you to swap your standard battery back should you wish.

Domestic Electrics

All your bike accessories are still powered. Some believe that not using the circuit breaker direct to the controller removes the safety of the circuit breaker. However, all our batteries have a full working BMS. Any power shorts or irregular current and the BMS shuts down. This is much more sensitive and accurate than a mechanical breaker (you may note that the Sur Ron Ultra Bee does not use a circuit breaker and relies on the BMS alone).

Battery Compartment Lids or Lifting Kits

Because of the extra battery height (385mm) minor modification will needed to your bike.

There are several options:

#1 Fit an aftermarket battery compartment lid found here: /product/talaria-battery-compartment-injection-moulded-battery-lid-to-fit-taller-batteries-not-3d-printed/

#2 Remove the battery plastic base tray in the bike (simply remove the 5 small allen key bolts from the top looking down) and fit our 5mm spacer between the metal battery lid catch and the lid (spacers provided)

#3 Seat Lift Kit option:https://www.electroncycles.co.uk/product/talaria-mx-seat-lift-kit-black-full-e-charged/

Specifications for Talaria Battery

SKI 62Ah20s BatteryNominal Voltage: 72VHVC: 84VLVC: 59VDC line 220A burst 350 (Setting over 220A may cause the BMS to trip if throttle held wide open for too long)Max Power rating (Discharge): 18,000 WattsMax Phase Amps: 700AHeight 385mmWeight 19KG1 x Air WedgeBMS monitoring individual series condition with balanced charging.An integrated cord handle for lowering the battery in and out.

Connecting To Bike

When connecting the battery to the bike and to avoid a spark, turn the red trip switch on the bike to off. Connect the older original power cable and then turn the red trip to on. Then connect the new power leads. Removing the battery has no special order.

Battery Charging

First time charging is VERY important. Always connect the charger to the battery with the charger powered up at the mains first. This will stop a Connection Spark. The battery needs a Balance Charge on first charge. Please charge for 12 hours first time. Always charge your battery in a safe place and never unsupervised.

Charger NOT Included

Our recommended charger for this battery is: /product-category/batteries-chargers/72v-20s/page/3/

This Battery will not work with an original standard Talaria Controller